RDLohrs T-Rex 500 Flybarless Pitch Alignment Tool

Use this nifty tool to figure out your blade pitch the old fashioned way. Allows you to mount a flybar to your helicopter so your pitch gauge still works.

Instructions:
- Center a 450 flybar (not included) into the slotted top piece (Part A).
- Place the head mount (Part B) over the flybar and top piece (Part B), feet side up.
- Mount the assembly onto the head assuring the feet rest evenly as shown.
- Screw into place with the head button screw (not included).
- Now you pitch gauge can be sighted along the 450 flybar.

Note: Peel protective paper off all Lexan before use (if there is any)
Note: Milling artifacts can be removed by scraping carefully along the edges with a fingernail an Exacto knife.
Note: Edges can be sanded with 220 grit sand paper if there are rough edges or burrs. .